After warming up, idle speed is below specifications without load (MIL works OK, no DTCs set)

After warming up, idle speed is below specifications without load (MIL works OK, no DTCs set)

Diagnostic procedure

1- Do the carbon accumulation check- Also check for

Incorrect valve timing or clearance adjustment

See also:
CKP Sensor Removal and Installation
CKP Sensor Removal and Installation 1 Torque: N·m (kgf·m, lbf·ft) Replace *1 Loosen 1.Engine Undercover - Remove 2.CKP Sensor Cover - Remove 3.CKP Sensor - Remove 4.All...
How to Connect the HDS
How to Connect the HDS 1- Turn the vehicle to the OFF (LOCK) mode- 2- Connect the HDS to the DLC (A) located under the driver's side of the dashboard- 3- Turn the vehicle to the ON mode, but...
A/F Sensor Removal and Installation
A/F Sensor Removal and Installation Special Tools Required ImageDescription/Tool NumberO2 Sensor Wrench Snap-on S6176 or equivalent, commercially available NOTE: Where icon is shown, click...