CKP Sensor Removal and Installation

CKP Sensor Removal and Installation

1

Torque: N·m (kgf·m, lbf·ft)

Replace

*1

Loosen

1.Engine Undercover - Remove

2.CKP Sensor Cover - Remove

3.CKP Sensor - Remove

4.All Removed Parts - Install

1- Install the parts in the reverse order of removal with a new O-ring- 5.CKP Pattern - Clear/Learn

NOTE: When replacing the CKP sensor, do this procedure.

See also:
How to Set Readiness Codes
How to Set Readiness Codes Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes) The vehicle has certain readiness codes that are part of the on-board diagnostics for the...
Engine will not start (MIL works OK, no DTCs set, security indicator stays on or flashes)
Engine will not start (MIL works OK, no DTCs set, security indicator stays on or flashes) Diagnostic procedure 1- Check the keyless access system.
Cold fast idle too low (MIL works OK, no DTCs set)
Cold fast idle too low (MIL works OK, no DTCs set) Diagnostic procedure 1- Do the PCM idle learn procedure- 2- Check the idle speed- 3- Do the carbon accumulation check.