Cylinder Bore Honing CR-V

Cylinder Bore Honing

1.Oil Jet - Remove

2.Cylinder Bore - Honing

1- Measure the cylinder bores. If the engine block is to be reused, hone the cylinders and remeasure the bores. Only scored or scratched cylinder bore must be honed- 2- Hone the cylinder bores with honing oil and a fine (400 grit) stone- NOTE:

Use only a rigid hone with 400 grit or finer stone such as Sunnen, Ammco, or equivalent-

Do not use stones that are worn or broken- Honing Pattern:

Within 30 60 degree cross-hatch pattern (A)

3- When honing is complete, thoroughly clean the engine block of all metal particles. Wash the cylinder bores with hot soapy water, then dry and oil them immediately to prevent rusting- NOTE: Never use solvent, it will only redistribute the grit on the cylinder walls- 4- If scoring or scratches are still present in the cylinder bores after honing to the service limit, rebore the engine block. Some light vertical scoring and scratching is acceptable if it is not deep enough to catch your fingernail, and does not run the full length of the bore- 3.All Removed Parts - Install

1- Install the parts in the reverse order of removal.

See also:
Fuel and Emissions Systems Symptom Troubleshooting - Engine will not start, engine starts but stalls immediately, or engine is hard to start CR-V
Engine Fuel and Emissions Systems Symptom Troubleshooting - Engine will not start, engine starts but stalls immediately, or engine is hard to start Engine will not start, engine starts but...
Valve Inspection CR-V...4827
Valve Inspection 1.Valve - Remove 2.Valve - Inspect 1- Measure the valve in these areas- Intake Valve Dimensions A Standard (New): 111.20 111.80 mm (4.3779 4.4016 in) B Standard...
Engine Oil Jet and Bolt Removal, Installation, and Inspection CR-V
Engine Oil Jet and Bolt Removal, Installation, and Inspection 1 Torque: N·m (kgf·m, lbf·ft) 1.Crankshaft - Remove 2.Oil Jet Bolt - Remove 3.Oil Jet - Remove 4.All Removed Parts -...