Drive Belt Auto-Tensioner Air Bleeding CR-V

Drive Belt Auto-Tensioner Air Bleeding

1.Drive Belt - Remove

NOTE: After the drive belt is removed, remove the pin from the drive belt auto-tensioner.

2.Drive Belt Auto-Tensioner - Air Bleed

1- Attach a socket wrench to the drive belt auto-tensioner from above the engine. Slowly (at least 3 seconds) compress the auto-tensioner in the direction shown, the full length of its stroke, then slowly (at least 3 seconds) move the auto-tensioner in the opposite direction, the full length of its stroke. Repeat this operation three times- 3.All Removed Parts - Install

1- Install the parts in the reverse order of removal.

See also:
PCV Valve Inspection CR-V
PCV Valve Inspection 1.PCV Valve - Inspect 1- Remove the harness holder mounting bolt (A). 2- Remove the harness ground mounting bolt (B)- 3- Remove the harness clamp (C), and move the... Camshaft Timing Inspection CR-V
Camshaft Timing Inspection 1.Cylinder Head Cover - Remove 2.Camshaft Timing - Inspect 1- Turn the crankshaft to align No. 1 position at top dead center (TDC); the white mark on the... DLC Circuit Troubleshooting CR-V...8195
Engine DLC Circuit Troubleshooting ElectronicCircuitSchematics-button DLC Circuit Troubleshooting NOTE: If you suspect the HDS or the HDS DLC cable may be the source of the communication...