EVAP Canister Removal and Installation CR-V

EVAP Canister Removal and Installation

1.Front Floor Undercover - Remove

2.EVAP Canister Assembly - Remove

1- Disconnect the fuel line quick-connect fitting (A)- 2- Press the tab (B) and disconnect the fuel vent hose (C)-

3- Disconnect the hoses (A)- 4- Disconnect the connectors (B)- 5- Remove the EVAP canister assembly (C)- 3.EVAP Canister - Remove

1- Remove the FTP sensor (A)- 2- Remove the EVAP canister (B)- 3- Remove the FTP sensor subharness (C), the EVAP canister vent shut valve case (D) and the EVAP canister filter (E) if needed- 4.All Removed Parts - Install

1- Install the parts in the reverse order of removal- NOTE: When install the hoses, align the marks (A) on hoses and each part.

See also:
PCM Update CR-V
PCM Update Special Tools Required ImageDescription/Tool NumberMVCI unit with the latest control module (CM) update software installed NOTE: High temperature in the engine compartment might...
Ignition Coil and Spark Plug Removal and Installation CR-V...4777
Ignition Coil and Spark Plug Removal and Installation 1.Ignition Coil - Remove 1- Disconnect the connectors (A)- 2- Remove the ignition coils (B)- 2.Spark Plug - Remove 3.All...
Cam Chain Case Oil Seal Replacement CR-V
Service Manual Cam Chain Case Oil Seal Replacement Special Tools Required ImageDescription/Tool NumberBelt Tension Release Tool Snap-on YA9317*, commercially availableCrankshaft Pulley Holder...