Engine stalls when shifted to D position/mode from N position/mode CR-V

Engine stalls when shifted to D position/mode from N position/mode

Probable cause(s)

Drive pulley, driven pulley, pulley shaft, steel belt, and pulley related parts worn or damaged

Reverse brake defective

Reverse brake piston stuck

Torque converter assembly defective

Engine output low

Notes

Check the drive pulley, the driven pulley, the pulley shafts, the steel belt, and pulley related parts for wear and damage. If there are worn or damaged, replace the transmission housing assembly-

Inspect the reverse brake piston and the O-rings. Check the spring retainer for wear and damage. Inspect the clearance between the brake end-plate and the top disc. If the clearance is out of tolerance, inspect the brake discs and plates for wear and damage. If the discs and plates are worn or damaged, replace them as a set. If they are OK, adjust the clearance with the brake end-plate-

Inspect the torque converter assembly for wear and damage.

See also:
Rear Differential Pump Motor Removal and Installation CR-V...8522
Service Manual Rear Differential Pump Motor Removal and Installation 2191S8 1.Vehicle Lift 1- Raise the vehicle on a lift, and make sure it is securely supported- 2.Rear Differential...
A/T gear position indicator does not work CR-V
A/T gear position indicator does not work Probable cause(s) F-CAN communication line error Gauge control module defective Transmission range switch defective or out of adjustment PCM...
CVT Forward Clutch Clearance Inspection CR-V
Service Manual CVT Forward Clutch Clearance Inspection Special Tools Required ImageDescription/Tool NumberSnap Ring Pliers 07LGC-0010100Clutch Compressor Attachment 07ZAE-PRP0100Clutch...