Engine stalls when shifted to R position/mode from N position/mode CR-V

Engine stalls when shifted to R position/mode from N position/mode

Probable cause(s)

Drive pulley, driven pulley, pulley shaft, steel belt, and pulley related parts worn or damaged

Forward clutch assembly defective

Planetary carrier worn or damaged

Thrust needle bearing on planetary carrier seized, worn or damaged

Thrust washer on planetary carrier seized, worn, or damaged

Torque converter assembly defective

Engine output low

Notes

Check the drive pulley, the driven pulley, the pulley shafts, the steel belt, and pulley related parts for wear and damage. If there are worn or damaged, replace the transmission housing assembly-

Inspect the clearance between the forward clutch end-plate and the top disc-

Check the planetary carrier for wear and damage. If the planetary carrier is worn or damaged, replace it and also check the planetary carrier pinion gears, the reverse brake, and the drive pulley shaft splines for wear and damage-

Check the thrust needle bearing and the thrust washers on the planetary carrier for wear and damage. If the thrust needle bearing or the thrust washer are worn or damaged, replace them and adjust the clearance with the thrust shim-

Inspect the torque converter assembly for wear and damage.

See also:
MTF Replacement CR-V
Service Manual MTF Replacement 1.Vehicle Lift 1- Raise the vehicle on a lift, and make sure it is securely supported- 2.Engine Undercover 1- Remove the engine undercover (A)- 3.MTF...
Shift Lever Disassembly and Reassembly CR-V
Shift Lever Disassembly and Reassembly 1.Shift Lever Assembly - Exploded View Exploded View NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an...
Transmission Range Switch Removal and Installation CR-V...8558
Service Manual Transmission Range Switch Removal and Installation 2181T8 Removal 1.Transmission Range Switch Cover 1- Remove the transmission range switch cover (A)- 2.Transmission...