Excessive idle vibration in N and P positions/modes CR-V...4964

Excessive idle vibration in N and P positions/modes

Probable cause(s)

Forward clutch assembly defective

Input shaft worn or damaged

Reverse brake defective

Torque converter assembly defective

Engine output low

PCM defective

Notes

Inspect the clearance between the forward clutch end-plate and the top disc-

Inspect the input shaft assembly for wear and damage. If the input shaft is worn or damaged, replace it and also check the related part of the input shaft assembly for wear and damage-

Inspect the reverse brake piston and the O-rings. Check the spring retainer for wear and damage. Inspect the clearance between the brake end-plate and the top disc. If the clearance is out of tolerance, inspect the brake discs and plates for wear and damage. If the discs and plates are worn or damaged, replace them as a set. If they are OK, adjust the clearance with the brake end-plate-

Inspect the torque converter assembly for wear and damage.

See also:
Transfer Oil Seal Replacement CR-V
Service Manual Transfer Oil Seal Replacement Special Tools Required ImageDescription/Tool NumberCompanion Flange Holder 07RAB-TB4010BHolder Handle 07JAB-001020BDriver Handle, 15 x 135L...
Transmission Housing Driven Pulley Shaft Bearing Replacement CR-V
Transmission Housing Driven Pulley Shaft Bearing Replacement Special Tools Required ImageDescription/Tool NumberAdjustable Bearing Puller, 25 40 mm 07736-A01000B*Driver Handle, 40 mm I.D....
Shift Lock Solenoid Removal and Installation CR-V
Service Manual Shift Lock Solenoid Removal and Installation 743145 NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you...