Shift Lever Disassembly and Reassembly CR-V

Shift Lever Disassembly and Reassembly

1.Shift Lever Assembly - Exploded View

Exploded View

NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*)-

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repair or service- 1.Shift Lever Knob Cover - Remove

2.Shift Lever Knob - Remove

NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*)- 1- Expand the lock tab (A), then remove the shift lever knob (B)- 3.Shift Lever Knob Ring - Remove

NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*)- 4.Center Console - Remove

5.A/T Gear Position Indicator Panel Light Bulb - Remove

6.A/T Gear Position Indicator Panel Light Subharness - Remove

7.Shift Lock Release - Remove

1- Expand the lock tab (A), then remove the shift lock release (B)- 8.A/T Gear Position Indicator Panel - Remove

NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*)- 1- Expand the lock tabs (A), then remove the A/T gear position indicator panel (B)- 9.Select Cover - Remove

10.Shift Lock Unit - Remove

NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*)- 1- Disconnect the connectors (A)-

2- Remove the harness clamps (A)-

3- Release the lock tab (A) and turn the pivot pin (B) counterclockwise using a hex wrench (C) as shown, and pull it- 4- Remove the shift lock unit (D) while releasing the lock tabs (E)- 11.Shift Lock Solenoid - Remove

NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*)- 1- Pull the shift lock solenoid (A) out by expanding the lock tabs (B)-

2- Remove the shift lock solenoid (A)- NOTE: The shift lock solenoid consists of the solenoid (B), the solenoid plunger (C), and the plunger spring (D)- 12.Shift Lock Stop/Stop Cushion - Remove

13.Park Pin Switch/A/T Gear Position Indicator Panel Light Harness - Remove

NOTE: The park pin switch and the A/T gear position indicator panel light harness are not available separately. Replace the park pin switch and the A/T gear position indicator panel light harness as a set- 1- Remove the park pin switch (A)-

2- Remove the park pin switch/A/T gear position indicator panel light harness (A)- 14.All Removed Parts - Install

1- Install the parts in the reverse order of removal.

See also:
CVTF Warmer Removal and Installation CR-V
CVTF Warmer Removal and Installation NOTE: Keep all foreign particles out of the transmission- 1.Radiator Coolant - Drain 2.Front Grille Cover - Remove 3.Air Cleaner - Remove 4.Resonator...
CVT Differential Carrier Bearing Preload Inspection CR-V...6946
Service Manual CVT Differential Carrier Bearing Preload Inspection Special Tools Required ImageDescription/Tool NumberPreload Inspection Tool 070AJ-5T0A100Bearing Driver Attachment, 62 x 68 mm...
Transmission Fluid Warmer Removal and Installation CR-V
Service Manual Transmission Fluid Warmer Removal and Installation NOTE: Keep all foreign particles out of the transmission- 1.Vehicle Lift 1- Raise the vehicle on a lift, and make sure it...