Transmission Housing Driven Pulley Shaft Bearing Replacement CR-V

Transmission Housing Driven Pulley Shaft Bearing Replacement

Special Tools Required

ImageDescription/Tool NumberAdjustable Bearing Puller, 25 40 mm 07736-A01000B*Driver Handle, 40 mm I.D. 07746-0030100

*: 07736-A01000B must be used with commercially available 3/8"-16 slide hammer-

NOTE: Apply a light coat of clean transmission fluid on all parts before installation- 1.Driven Pulley Shaft Bearing - Remove

1- Remove the bearing set plate (A)-

2- Remove the driven pulley shaft bearing (A) using the 25 40 mm adjustable bearing puller and a commercially available 3/8"-16 slide hammer (B)-

3- Remove the oil guide plate (A)- 2.Driven Pulley Shaft Bearing - Install

1- Install the oil guide plate (A)-

2- Install the driven pulley shaft bearing (A) until it bottoms using the 40 mm I.D. driver handle-

3- Install the bearing set plate (A).

See also:
Clutch Master Cylinder Removal and Installation CR-V...6927
Service Manual Clutch Master Cylinder Removal and Installation 211101 NOTE: Use fender covers to avoid damaging painted surfaces- Do not spill brake fluid on the vehicle; it may...
EPS System Description - Motion Adaptive-EPS Control CR-V...7115
Steering EPS System Description - Motion Adaptive-EPS Control Overview Motion adaptive-EPS control performs the steering torque correction control coordinated with VSA system for stabilizing...
Steering Lock Removal and Installation CR-V...8583
Service Manual Steering Lock Removal and Installation 725100 SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing...